Home > Products > Smoke and fire protection > Controls / Electrical accessoires
Controls / Electrical accessories
Controls are mandatory for all automatic fire protection systems.
In case of malfunction, the smoke and fire protection closures would not fulfil their task and therefore not contribute to fire fighting. They evaluate the fire detection signals and trigger the closures independently of energy.
Characteristics
-
building authorities approved locking device
-
24V or 230V motor control units, roll-down without external power supply
-
smoke switch / smoke detector
Type
RZ-24 locking system and motor terminal box
230V Fail Safe
Release unit for textile smoke barriers and fire protection closures. With membrane keypad for operation and visual and acoustic display. Integrated manual release button.
With the optionally available power pack, short-term power grid failures (a few minutes) can be bridged e.g. until a backup generator starts up.
Connection and evaluation of a fire alarm panel signal possible, connection options for fire detection elements, additional manual release button.
MS-15/23
230 V Failsafe
Central- / group control of smoke barriers and fire protection closures
230V AC Fail Safe Power supply in case of power grid failures via maintenance-free battery pack, automatic closing / roll-down in case of an alarm.
Potential-free signal output for forwarding to superordinated control, evaluation of on-site, potential-free fire alarm signals.
Connection options for fire detection elements and manual release buttons.
MS-15/17
24 V Failsafe
Central / group control of smoke barriers and fire protection closures 24V DC Fail Safe Battery-buffered power supply, 24 V DC with voltage monitoring, automatic closing / roll-down in case of alarm or power grid failure after approx. 2 minutes.
Potential-free signal output for forwarding to superordinated control, evaluation of on-site, potential-free fire alarm signals.
Connection options for fire detection elements and manual release buttons.
MS-15/24
24 V Standard
Central / group control of smoke barriers and fire protection closures 24V DC Standard Battery-buffered power supply, 24 V DC with voltage monitoring, automatic closing in case of alarm or power failure after approx. 2 minutes.
Potential-free signal output for forwarding to superordinated control, connection options for fire detection elements and manual release buttons.
Connection options for fire detection elements and manual release buttons.
Manual release / push button DKT PRO
Manual alarm triggering.
Red trigger button and reset button concealed from the outside.
Protected against unauthorised or unintentional actuation by means of a glass pane.
Aluminium casing, IP40, case colour orange.
Manual release / push button DKT 02
Manual alarm triggering.
Red trigger button and reset button concealed from the outside.
Protected against unauthorised or unintentional actuation by means of a glass pane.
Plastic casing, IP20.
Case available in following colours : yellow, grey and orange.
S65 optical smoke detector
The Series 65 optical smoke detector comes with a pulsating LED and a photodiode inside the smoke detector housing.
Thermal differential detector S65
The Series 65 thermal differential detector monitors the temperature of the ambient air using a dual thermistor network that outputs voltage proportional to the air temperature.